Wincor Nixdorf TH200, Programmer'S Manual

Page: 14 / 106

Programmer’s Guide
TH200
14
DLE DC4 n m t Generate pulse at real-time
Code:
Range:
Description:
Notes:
Reference:
ASCII DLE DC4 n m t
Hex 10 14 n m t
Decimal 16 20 n m t
n = 1
m = 0, 1
1
≤
t
≤
6
Outputs the pulse specified by t to connector pin m as follows:
m Connector pin
0 Drawer kick-out connector pin 2
1 Drawer kick-out connector pin 5
The pulse ON time is [t × 100 ms] and the OFF time is [t × 100ms].

When the pulse is output to the connector pin specified while ESC p or DEL DC4 is
executed while this command is processed, this command is ignored.

The printer executes this command upon receiving it.

With a serial interface model, this command is executed even when the printer is
off-line, the receive buffer is full, or there is an error status.

With a parallel interface model, this command cannot be executed when the printer is
busy.

If print data includes the same character strings as this command, the printer performs
the same operation specified by this command. The user must consider this.

This command should not be used within the data sequence of another command that
consists of 2 or more bytes.

This command is effective even when the printer is disabled with ESC = (Select
peripheral device).
ESC p
ESC FF Print data in page mode
Code:
Description:
Notes:
Reference:
ASCII ESC FF
Hex 1B 0C
Decimal 27 12
In page mode, prints all buffered data in the printing area collectively.

This command is enabled only in page mode.

After printing, the printer does not clear the buffered data, setting values for ESC T and
ESC W , and the position for buffering character data.
FF, ESC L, ESC S