WINCODE LP423N, User Manual

Page: 58 / 68

LP4 USER MANUAL
- 57 -
5.1 Printing Summary
Printer
Summary
•
Listing printer information
Send Command window
•
Start Calibration
Run the sensor calibration after the label material has
changed. If it is the same material but different size, only need
to adjust the “Page Setup” at WinLabel. It is recommended to
use “auto detection”.
•
Get Label Size: get the detected value of label size at the right
table
•
Get sensor value: get the detected value of the sensors at the
right table
•
Cutter Turning Clockwise: cutter cuts label from top to bottom
(Fully cut)
•
Cutter Turning Anti-Clockwise: cutter cuts from bottom to top
(Not completely cut-off the label, the user can tear off the
label)
•
Restore Factory Defaults: restore the parameters of the printer
to factory default settings.
•
Printer Self Test: print out the internal settings of the printer.
•
Reset Printer: restart the printer
•
Enter DUMP Mode: enter to the DUMP mode (Press
“menu” for returning to the original mode)
Settings
Please refer to the 3.5.2 Settings
File
Management Check the detail files in the different store spaces
Send
command
Be able to send command to the printer, please refer to the Printer
Command Manual.
Unit- Tools
page
Printing measurements: millimeter (mm), centimeter (cm), inch (in).