Page 32 of 49
Document No.: 006020
Revision: P
OWNERS OPERATING & MAINTENANCE MANUAL
PHLEBOTOMY COLLECTION
1.
Use
TWO (2) people
! Use the included 3/16” Hex (Allen) Wrench and the included “Multi-Size”
Wrench to remove the
nut, lock-washer and shoulder bolt
from the square post on the
base
assembly.
2.
Align the
Seat Bracket
and
Seat Post
3.
Slowly lower the seat bracket down onto the seat post until the hole in the seat bracket is aligned
with a hole on the post for the desired seat height. Re-install the shoulder bolt and locknut into
one of the aligned sets of holes to obtain desired seat height.
TIGHTEN THE NUT AND LOCK-
WASHER ON SHOULDER BOLT!
The seat height of the
2578 Elevate BDC
can be adjusted during setup.
THE SEAT ASSEMBLY IS VERY HEAVY - TO ADJUST THE HEIGHT, THE CHAIR
MUST BE SUPPORTED BY SOMEONE WHO CAN LIFT OVER 50 LBS.
*TEAM LIFT RECOMMENDED*
COMPLETELY TIGHTEN SHOULDER BOLT, LOCKWASHER AND NUT
BEFORE USING, OTHERWISE, INJURY COULD RESULT!
Have your helper grasp the seat by the metal seat frame to hold the
seat assembly steady and prevent it from dropping!
SEAT HEIGHT SET-UP AND ADJUSTMENT
