FIG 1
Page 10 of 49
Document No.: 006020
Revision: P
OWNERS OPERATING & MAINTENANCE MANUAL
PHLEBOTOMY COLLECTION
SEAT INSTALLATION
FAILURE TO COMPLETELY TIGHTEN THE SEAT MOUNTING
SCREWS COULD RESULT IN SERIOUS INJURY.
1.
Position Chair Frame in upright position. Check tightness of all installed screws, bolts, nuts and other
fasteners in case they loosened during shipping.
2.
Align the mounting holes on the plastic Seat with the Seat Support holes. Hole spacing of Seat and
Seat Supports will be narrower toward front of chair. Seat can only be installed facing one direction.
(
FIG 1)
3.
Using the included wrench (or your own 5/16” tool), install the four (4) included Seat Screws through
the holes of Chair Frame, and into the four (4) holes on bottom of the plastic Seat. Make sure screws
are completely tightened. (
FIG 1)
NOTE:
These “special” screws
MUST BE USED
for maximum grip in this seating application. They can be
slightly difficult to “get started” in the holes on the plastic Seat.
TIP
: Use even pressure and, if available, a “5/16” nut-driver” (screwdriver-type handle with a 5/16” socket
on end) however, this task can be accomplished with the included wrench.
