Maintenance
Keep the tools clean and always remove dust and other pollutants. To keep the tool well maintained
it should frequently be lubricated (transmission, bearing) to keep the tool flexible in its use. Always
check the electricity cable, the plug and the switches to ensure the machine is in a good condition. The
produced tools are subject to strict quality controls.
Exchanging the carbon brushes
If the carbon brushes have reached their wear limit they need to be exchanged. Loosen the screw of
the cover of the carbon brushes with a slot screwdriver. Then remove the cover and replace the ori-
ginal carbon brushes with the ones included in delivery. Place the cover back on and screw it on
tightly.
Please note:
The sander has a built in self absorbing system, thus connecting a vacuum cleaner is not ne-
cessary.
The drywall sander has a special construction on its shaft which is connected to the sanding
pad. If the sander encounters an uneven surface whilst sanding, the sanding pad can adjust
autonomously and allows for smooth results never the less.
Inner structure: two casing elements protect the motor from dust.
The dust bag has a small hole from where air can escape. If the dust bag is filled up to 50 %
with dust, please empty it out.
When you finish working with the sander, please hold it against the surface to allow it to ab-
sorb any remaining dust particles for a few seconds longer.
© by WilTec Wildanger Technik GmbH
Item 61857
Page 10
http://www.WilTec.de
http://www.aoyue.eu
02 2021
-1
