WilTec 50790, Manual

Page: 18 / 43

© by WilTec Wildanger Technik GmbH Seite 18
http://www.wiltec.info
Assembly Procedure
1. Set up the tripod base:
a. Set the base on the
floor, resting on its
casters.
b. Press down on the
slide yoke ring. Hold
the ring down while
you swing the two
forward legs out until
the yoke ring snaps
into the locking hole
on the bottom of the
slide tube. (See Figu-
re 1)
c. To prevent the tripod
base from rolling
backward during as-
sembly,
lower the
backstop as shown.
2. Set the frame assembly
onto the two "V" angles on
the tripod base, and lower
the frame about 1 in. until it
is secured by the angles.
Before continuing, be sure
the frame is pushed all the
way down and is held se-
curely by the angles.