8
Need help?
www.WilsonElectronics.com
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
3301 East Deseret Drive, St . George, UT 84790
web:
www .WilsonElectronics .com
email:
tech@wilsonelectronics .com
phone:
866-294-1660
local:
435-673-5021
fax:
435-656-2432
Copyright © 2014 Wilson Electronics, LLC All rights reserved .
U .S . Patent Nos .– 7,221,967; 7,729,669; 7,486,929; 7,409,186; 7,783,318; 8,583,034; 8,583,033; 7,684,838; D626,953; 8,473,018
Disclaimer:
The information provided by Wilson Electronics, LLC is believed to be complete
and accurate . However, no responsibility is assumed by Wilson Electronics, LLC
for any business or personal losses arising from its use, or for any infringements
of patents or other rights of third parties that may result from its use .
111283_Rev01_01 .23 .14
Signal Booster Specifications
Sleek
Model Number
460006
Connectors
SMA-Female
Antenna Impedance
50 Ohms
Frequency
824-894 MHz/1850-1990 MHz
3
Power output for single cell phone (dBm)
800 MHz
1900 MHz
Uplink
Downlink
22 .9
-28 .0
25 .2
-29 .1
Noise Figure (typical downlink/uplink)
3 dB nominal
Isolation
> 40 dB
Power Requirements
5 .5 V 1A
Each Signal Booster is individually tested and factory set to ensure FCC compliance . The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware . The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase
coverage of authorized frequency bands only . If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected . If
a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the
power off on that band . For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute .
After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted by
momentarily removing power from the Signal Booster . Noise power, gain, and linearity are maintained by the Signal Booster’s microprocessor .
30-Day Money-Back Guarantee
All Wilson Electronics products are protected by Wilson Electronics 30-day money-back guarantee . If
for any reason the performance of any product is not acceptable, simply return the product directly to the
reseller with a dated proof of purchase .
2-Year Warranty
Wilson Electronics Signal Boosters are warranted for two (2) years against defects in workmanship and/or
materials . Warranty cases may be resolved by returning the product directly to the reseller with a dated proof
of purchase .
Signal Boosters may also be returned directly to the manufacturer at the consumer’s expense, with a dated
proof of purchase and a Returned Material Authorization (RMA) number supplied by Wilson Electronics .
Wilson Electronics shall, at its option, either repair or replace the product . Wilson Electronics will pay for
delivery of the repaired or replaced product back to the original consumer if located within the continental U .S .
This warranty does not apply to any Signal Boosters determined by Wilson Electronics to have been subjected
to misuse, abuse, neglect, or mishandling that alters or damages physical or electronic properties .
Failure to use a surge protected AC Power Strip with at least a 1000 Joule rating will void your warranty .
RMA numbers may be obtained by contacting Technical Support at 866-294-1660 .
