English
78
WILO SE 02/2014
Tab. 5 – Menu items
6.2.6
Operation levels
The parameterisation of the switchgear is divided into the menu areas
EASY and EXPERT.
For rapid commissioning using the factory presets, it is enough to set
the control mode and setpoint 1 in the EASY area.
The EXPERT area is provided for changing other parameters and for
reading out data from the device.
Menu level 7.0.0.0 is reserved for Wilo customer service.
7
Installation and electrical
connection
Safety
DANGER! Risk of fatal injury!
There is a risk of fatal injury from electric shock when working on
electrical equipment.
• Danger from electrical current must be eliminated.
• Local directives or general directives [e.g. IEC, VDE etc.] and
instructions from local energy supply companies must be adhered
to.
DANGER! Risk of fatal injury!
Incorrect installation and improper electrical connections can be
life-threatening.
• Have the electrical connections established by licensed electri-
cians only, in compliance with the applicable regulations!
• Adhere to regulations for accident prevention!
7.1
Installation
Wall-mounted installation (WM):
• Fasten the wall model by means of four 8 mm screws. While doing so,
the protection class is to be ensured using suitable measures.
Floor model, base-mounted (BM):
• The floor model is set up free-standing on a level surface (with suffi-
cient bearing capacity). An up-right panel support with a height of
100 mm is available for the cable inlet as standard. Other supports are
available on request.
6.0.0.0
Fault signals
–
–
6.1.0.0
Reset of the fault signals
–
–
6.1.0.
1
to
6.1.
1.6
Fault signal of the last 16 fault signals
(FIFO principle)
–
–
Menu no./
notes
Display
Description
Parameter range
Factory setting
Summary of Contents for SC-HVAC SC
