Wilo Rexa MINI3 Installation And Operating Instructions Manual Download Page 4

en

4

Installation and operating instructions • Wilo-Rexa MINI3 • Ed.03/2022-05

1

Safety

1.1

About these instructions

These instructions form part of the product.
Compliance with the instructions is essential for
correct handling and use:

Read the instructions carefully before all
activities.

Keep the instructions in an accessible place at
all times.

Pass the instructions on to a subsequent
owner.

Observe all product specifications.

Observe the markings on the product.

The language of the original operating instruc-
tions is German. All other languages for these
instructions are translations of the original op-
erating instructions.

Failure to observe the instructions will result in
danger to persons or damage to property. The
manufacturer is not liable for damage caused
by:

Improper use.

Incorrect operation.

1.2

Digital instructions

The digital version of the instructions is avail-
able on the following product page:
http://qr.wilo.com/405

1.3

Identification of safety instructions

In these installation and operating instructions,
safety instructions are displayed as follows:

Danger to persons: Safety instructions are

preceded by a corresponding symbol

 and are

shaded in grey.

Damage to property: Safety instructions start
with a signal word and are displayed 

without

a symbol.

Signal words

DANGER!

Failure to follow the instructions will result in
serious injuries or death!

WARNING!

Failure to follow the instructions can lead to
(serious) injury!

CAUTION!

Failure to follow the instructions can lead to
potentially irreparable property damage.

NOTICE!

Useful information on handling the product

Symbols

These instructions use the following symbols:

Danger caused by electric
voltages

Danger of explosion

Warning – risk of cuts and similar
injuries

Warning - risk of health damage

Personal protective equipment:
wear protective gloves

Personal protective equipment:
wear face mask

Personal protective equipment:
wear safety goggles

Useful information

1.4

Personnel qualifications

Persons aged 16 and over

Have read and understood the installation and
operating instructions

Children and persons with limited abilities in
the household

This device can be used by children from 8 years
of age as well as people with reduced physical,
sensory or mental capacities or lack of experi-
ence and knowledge if they are supervised or
instructed on the safe use of the device and
they understand the dangers that can occur.
Children are not allowed to play with the device.
Cleaning and user maintenance must not be
carried out by children without supervision.

Summary of Contents for Rexa MINI3

















Reviews: