Wilo DrainLift BOX, Installation And Operating Instructions Manual

Page: 29 / 52

en
Installation and operating instructions • Wilo-DrainLift BOX • Ed.06/2022-10 29
▶ Result
Identifying cross references
The name of the section or table is in inverted commas [“ ”]. The
page number follows in square brackets [ ].
2.2 Personnel qualifications
• Personnel have been instructed on locally applicable regula-
tions governing accident prevention.
• Personnel have read and understood the installation and oper-
ating instructions.
• Electrical work: qualified electrician
Person with appropriate technical training, knowledge and ex-
perience who can identify and prevent electrical hazards.
• Installation/dismantling work: trained specialist in plant tech-
nology for sanitary facilities
Fixation and buoyancy safeguards, connection of plastic pipes
• Maintenance work: skilled person (trained specialist in plant
technology for sanitary facilities)
Hazards caused by sewage, basic knowledge of lifting units, re-
quirements of EN 12056
Children and persons with limited abilities
• Persons under the age of 16: Use of this product is prohibited.
• Persons under the age of 18: Supervise them during use of the
product (supervisor)!
• Persons with limited physical, sensory or mental capacities: Use
of this product is prohibited!
2.3 Electrical work
• Electrical work must be carried out by a qualified electrician.
• Disconnect device from the mains and secure it against being
switched on again without authorisation.
• Observe applicable local regulations when connecting to the
mains power supply.
• Comply with the requirements of the local energy supply com-
pany.
• Train personnel on how to make electrical connections.
• Train personnel on the options for switching off the device.
• Observe the technical information in these installation and op-
erating instructions as well as on the rating plate.
• Earth the device.
• Arrange switchgears so as to be overflow-proof.
• Replace defective connection cables. Contact customer service.
2.4 Monitoring devices The following monitoring devices must be provided on-site:
Circuit breaker
The size and switching characteristics of the circuit breakers must
conform to the rated current of the connected product. Observe
local regulations.