8DR LED SERIES
INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065
Information contained herein is subject to change without notice.
PN #49091089
Page 4 of 4
REV.09/14/18JJ
DOWNLIGHT INSERT INSTALLATION
Step 8:
Connect downlight insert to power (see FIGURE 8.1)
A.
Connect the steel leader to the wire lanyard so the
downlight insert is supported. The fixture will need to
remain supported for remodel installations.
B.
Terminate all LED power cables (from 2-5) to the
corresponding LED input cables on the downlight insert.
Note:
During insert installation, always orient the LED input
cables toward the installed driver box.
FIG. 8.1
LED power cables
Steel leader
LED input cables
Wire lanyard
Downlight insert
DOWNLIGHT INSERT (BOTTOM VIEW)
Swing-out arm
(6) Stop tabs
Installation screws
(9/64th hex bit)
Swing-out arm
Swing-out arm
(6) Stop tabs
Step 9:
STANDARD CEILING: Install downlight insert to ceiling
SCA CEILING: Install downlight insert to sloped ceiling trim
A.
STANDARD CEILING: Maneuver the downlight insert up
through the ceiling cutout until the stop tabs are flush
against the ceiling plane.
SCA CEILING: Maneuver the downlight insert up through the
sloped ceiling trim until the stop tabs are flush against the
lower stop ring.
B.
While continuing to support the insert, use a 9/64” hex bit to
drive the (3) installation screws - this will cause the swing-
out arms to deploy, draw down, and clamp the insert in
place. (see FIGURES 9.1 & 9.2)
FIG. 9.1
Standard ceiling. New construction shown. Remodel version has no pan.
Swing-out arm
Downlight
Insert
FIG. 9.2
SCA ceiling.
Downlight
insert
Sloped
ceiling trim
Horizontal plane
Swing-out
arm (deployed)
