8DR LED SERIES
INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065
Information contained herein is subject to change without notice.
PN #49091089
Page 3 of 4
REV.09/14/18JJ
DRIVER BOX INSTALLATION
Step 5:
Install driver box to mounting pan (see FIGURE 5.1 )
A.
FOR NEW CONSTRUCTION ONLY: Maneuver the driver
box up through the ceiling cutout, rotate down 90 degrees,
then slide back between the mounting pan rails until it hits a
physical stop.
FOR REMODEL ONLY: Install junction box in ceiling plenum.
(see FIGURE 5.2) Maneuver the driver box up through the
ceiling cutout, place on the receiver bracket assembly.
B.
Reach up through the ceiling cutout and thread in the (2)
thumb screws to secure the driver box to the pan.
FIG. 5.1
Mounting
rail
Thumb screw
Flex conduit
Note: LED power cables
and steel leader were
removed for clarity
FIG. 5.2
Mounting
rail
Thumb screw
Flex conduit
Note: LED power cables
and steel leader were
removed for clarity
C.
Pull the LED power cable and steel leader down through
the ceiling cutout so they are accessible for the downlight
insert installation.
SCA TRIM INSTALLATION
(SKIP TO STEP 8 FOR STANDARD CEILING INSTALLATION)
Step 6:
Orient and align sloped ceiling trim. Align the trim mounting
screws (2x) with the pre-installed cage nuts located in the yoke
arm brackets. See FIGURE 6.1
Note:
The lower stop ring must run parallel with the yoke arm
brackets
FIG. 6.1
Lower stop ring
Yoke arm bracket
with cage nut
(1 per side)
Sloped celing trim
Mounting screw
(1 per side)
Step 7:
Install sloped ceiling trim
A.
Lift the sloped ceiling trim up into the ceiling cutout so the
mounting screws can engage the cage nuts.
B.
Tighten the screws until the trim flange has been drawn
securely against the ceiling surface.
C.
Pull the LED power cable and steel leader from the driver
box down through the sloped ceiling so they are accessible
for the downlight insert installation. See FIGURE 7.1
FIG. 7.1
(2-5) LED
power cables
Steel leader
Cage nut
Mounting
screw
