Assembly InstructIons
heritage two-seat glider
330-893-4212 • www.wildridge.com
lcc-104
© 2017
step 1
On a level surface, place the backrest (A) and the seat (B) on its
side, butting them up against each other. Lay the right arm/leg
assembly (C) onto the backrest and seat and fasten them together.
For the front leg use (2) 5/16” x 3 1/2” bolts and (2) 5/16” flange
nuts. For the back leg use (2) 5/16” x 5” bolts & (2) 5/16” flange nuts,
and for the armrest use (1) 5/16” x 3 1/2” bolt & (1) 5/16” flange
nut. Repeat with the left arm/leg assembly (D) on the other side.
step 2
Place the glider upright. On the backside, fasten the backrest to
the seat support using (2) 3” screws, as shown, through the
pre-drilled holes provided.
required tools:
- Mallet/Non Marring Hammer
(Do not use Metal Headed Hammer)
-Cordless Drill
-#2 Square Drive bit
- 1/2” and 9/16“ Wrench or Socket
Hardware:
-(4) 5/16” x 5” Bolts
-(8) 5/16 x 3“ Lag Bolts
-(6) 5/16” x 3 1/2” Bolts
-(8) 5/16“ Washers
-(10) 5/16” Flange Nuts
-(8) 3/8” x 2 1/2” Machine Bolts
-(8) 3/8” Locknuts
-(16) 3/8” Washers
-(2) 3” Screws
-(4) Glider Brackets
Parts:
A = (1) Backrest
B = (1) Seat
C = (1) Right Arm/Leg Assembly
D = (1) Left Arm/Leg Assembly
E = (2) Base Pieces
F = (2) Cross Members
Fasten screws through the backrest into the seat support.
D
A
b
c
e
(1) 5/16” x
3 1/2” bolt
& (1) 5/16”
Flange nut
(2) 5/16”
x 5” bolts
& (2) 5/16”
Flange
nuts
(2) 5/16” x
3 1/2” bolt
& (2) 5/16”
Flange nuts
A
b
c
e
F
F
