W24FXS 2015 - Quick Installation Guide - English
W24FXS 2015 - Quick Installation Guide - English
Page 2 of 4
RJ21 Wire Sequence (Pinout chart)
One RJ21 cable has 25 pairs of wires. The 25th pair is vacant, which means that one RJ21 interface supports up
to 24 calls.
Connection to power supply
Connect the gateway to the Power Supply using the cable provided
Turn the switch situated on the rear panel into “ON” position
Connection to the network
Connect the gateway’s WAN port to Wildix Switch using Ethernet cable
Notes:
The gateway should be connected via Ethernet cable to the same network as the PBX or an external
DHCP server (for instance Router)
As soon as the DHCP server assigns an IP address to the gateway, you can pass to the next step of the
gateway configuration
In case the PBX is used as a DHCP server, the gateway is detected on the network automatically
In case an external DHCP server is used, check the list of the active leases to detect the IP address
assigned to the gateway
Connection of analog phones
