W01-02PRI Installation Admin Guide - English
W01-02PRI Installation Admin Guide - English
Page 6 of 11
Before you start:
Your network interface must be set with an IP address in the 192.168.0.0/24 subnet (e.g. 192.168.0.11)
You must use an IPv4 Network
Make sure that your network connection is working
Steps
Connect a 10/100/1000 BaseT Ethernet RJ-45 cable into the ETH5ETH5/EXT Ethernet connector of the
device
Connect the other end of the cable into your PC
Validate the installation
Turn on the power sources that are used to power the PRI gateway at the circuit breaker
Turn on the power switch of the PRI gateway
Result
You can now use the 192.168.0.10 IP address to access your device's management interface.
Configuration of W01/02PRI
For remote/ unreachable media gateways behind NAT/ Firewall, follow our
.
.
Trunk Settings Guide, BRI/ PRI Trunk Settings
Logging on to the PRI gateway Web Interface
In your web browser, enter the IP address used by your device to communicate with the Management
Interface
If your computer is connected to the Ethernet port, commonly used to be connected to the LAN, i.e. ETH2
on most devices, use the 192.168.0.10 IP address
If your device is configured to use a DHCP with IPv4, use the DHCP- provided IP address
Enter "public" as your username and leave the password field empty
Note: Access W01/02PRI web interface via https only.
Note: After provisioning, use these credentials:
login: public
password: use the one indicated in the field "Password" in WMS -> Devices
