W-AIR Small Business Admin Guide
W-AIR Small Business Admin Guide
Page 7 of 12
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
7.
8.
The
menu opens; enter the value “FFFFFFFFFF” into the field “IPEI” and click
:
Handset
Save
Register a new handset to the W-AIR base station: on the handset open the menu
->
Connectivity
after the new handset is registered, it appears on the W-AIR SB web interface ->
Register;
Extensions
menu
Access the PBX via SSH and add PBX parameter “ResetHandset=yes” to the [wildixair] section of the /rw2
/etc/provision.conf. Documentation:
Perform logout procedure: dial 99 from the handset and follow the prompts
Remove PBX parameter “ResetHandset=yes” from the [wildixair] section of the /rw2/etc/provision.conf
[wildixair]
Step 3. Set up Repeaters
Proceed as follows:
Find the IP of the base station that you want to repeat (on the WMS devices list)
Access the base station's web interface, enter a username “admin” and a password that you can find in
the WMS Devices menu in the “Password” field of the given base station
Select
in the menu and click on
Repeaters
Add Repeater
Select Manually from the drop-down menu if it is present, then choose the Station ID (
)
DECT sync source
where you want to connect the Repeater and confirm by pressing the
button
Save
Reboot the Base station (go to
menu and click
). After the system reboots,
Management
Save and reboot
go back to the base station’s interface
Select
in the menu
Repeaters
Select a Repeater(s) you want to add to the chain and click on Register Repeater(s)
Now you have 5 minutes to turn on the Repeater(s)
