Wilan LIBRA 5800 AP, User Manual

Page: 86 / 156

Configuration
86 Libra 5800 Series User Guide
Using the Command Line
Libra 5800 units have a command line interface you can use to perform basic tasks while logged into
the configuration menus.
➧
To use the command line interface
1. Log onto a Libra 5800 and press Esc until the
wilan>
command line prompt appears.
2. Type the command after the prompt and press Enter .
3. Press Esc to return to the main menu.
OFDM Encoder Statistics
OFDM Encoder
Statistics
Describes Reed Solomon encoder statistics
Total Superframes
Encoded
Number of superframes encoded by the Reed Solomon encoder
Ethernet Frames
From Local
Number of Ethernet frames sent to the Reed Solomon encoder that
originated from the unit’s local stack
OFDM Unpacking Statistics
OFDM Unpacking
Statistics
Describes statistics on synchronization of OFDM superframes
Superframe Header
Errors
For Wi-LAN use only
Ethernet Header
Errors
For Wi-LAN use only
Synch Errors
For Wi-LAN use only
Late Poll
Responses
A Poll was sent to a CPE, but either there was no response or the
response was late.
Throughput Statistics
Average Throughput
Total throughput in bits per second (bps) with no overhead from the
Libra Unit; this measurement is made over a ten-second average
Maximum Throughput
Highest throughput in bps since the last statistics reset, with no
overhead