Configuration
74
Setting Tx Power
The transmitter power setting enables you to adjust the strength of the transmit signal sent from the
Libra unit to the antenna. The range is -3 dBm to 17 dBm.
➧
To set the Tx power
1. From the Main System Menu, select
Radio Configuration
and press
Enter
.
The Radio Configuration menu appears.
2. Select
Set Tx Power
and press
Enter
. The field highlights.
3. Type in the signal strength. The new signal strength is applied.
Radio Configuration
OFDM Station Type Base Station
RF Station Id [1..2047] -> 2
Sector Id [0..31] 1
Synchronization Id [0..1] 0
Base Station Tx Disable
Center Freq (kHz) 5787000
Set Tx Power (dBm) [-3...17] 17
Modulation Type QAM 16
Note: Changes on this menu aside from Tx Power require that
the unit be rebooted to take effect.
Summary of Contents for LIBRA 5800 AP
