32
WIKA operating instructions process transmitter, model UPT-2x
14068347.01 06/2014 GB/D
GB
9. Configuration via display and operating unit
9.1.2
Configuring level measurement
1.
Open the operating menu with [↵].
Select “Basic setting” and confirm with [↵].
2.
Select “Application” and confirm with [↵].
3.
Select “Level” and confirm with [↵].
4.
Select “Unit” and confirm with [↵].
5.
Select length unit and confirm with [↵].
Length unit is set.
6.
Select “Density” and confirm with [↵].
7.
Select “Density unit” and confirm with [↵].
8.
Select density unit and confirm with [↵].
Density unit is set.
9.
Select “Density value” and confirm with [↵].
10.
Set digit using [▲] [▼] and confirm with [↵]. The
cursor moves to the next digit. Repeat for each digit.
Density value is set.
11.
Go back two menu levels using [ESC].
Select “Mode” and confirm with [↵].
12.
Select “Level” and confirm with [↵].
Mode is set.
13. Perform a mounting correction.
See chapter 9.5 “Mounting correction (offset)”.
