5
WIKA operating instructions, model CTD9100-1100
14030725.02 08/2019 EN/DE
EN
3. Safety
3.1 Explanation of symbols
WARNING!
... indicates a potentially dangerous situation
that can result in serious injury or death, if not
avoided.
CAUTION!
... indicates a potentially dangerous situation
that can result in light injuries or damage to
equipment or the environment, if not avoided.
DANGER!
... identifies hazards caused by electric power.
Should the safety instructions not be observed,
there is a risk of serious or fatal injury.
WARNING!
... indicates a potentially dangerous situation that
can result in burns, caused by hot surfaces or
liquids, if not avoided.
Information
... points out useful tips, recommendations
and information for efficient and trouble-free
operation.
3.2 Intended use
The temperature dry-well calibrator is a portable unit, for
service functions and also for industrial and laboratory
tasks. The temperature dry-well calibrator is provided for
the calibration of thermometers, temperature switches/
thermostats, resistance thermometers and thermocouples.
The operational safety of the delivered instruments is only
assured if the equipment is employed for its intended use
(verification of temperature sensors). The given limit values
should never be exceeded (see chapter 12 “Specifications”).
The appropriate instrument should be selected depending on
the application; it should be connected correctly, tests carried
out and all components serviced.
This instrument is not permitted to be used in hazardous
areas!
The instrument has been designed and built solely for
the intended use described here, and may only be used
accordingly.
The technical specifications contained in these operating
instructions must be observed. Improper handling or
operation of the instrument outside of its technical
specifications requires the instrument to be taken out of
service immediately and inspected by an authorised WIKA
service engineer.
2. Short overview / 3. Safety
2.3 Scope of delivery
■
Temperature dry-well calibrator model CTD9100-1100
■
Power cord, 1.5 m [5 ft] with safety plug
■
Insert with four bores: 7 mm, 9 mm, 11 mm and 13.5 mm
[0.28 in, 0.35 in, 0.43 in and 0.53 in]
■
Drilled ceramic top insulator
■
Insert replacement tools
■
Connection cable
■
Operating instructions
■
Calibration certificate
Cross-check scope of delivery with delivery note.
The calibrators/micro calibration baths are
delivered in special protective packaging.
The packaging must be set aside so that the
calibrator or the micro calibration bath can
be sent safely back to the manufacturer for
recalibration or repair.
The equalizing block is packed separately to
avoid breaking the ceramic tube during transport.
The block must be fitted into the calibrator when
it is ready to be used.