5 Managing Switch
56
Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018
To access this page, click L2 Switching > GARP > GVRP Settings.
The following table describes the items in the previous figure.
Item
Description
Status
Click to enable or disable the GARP VLAN Registration Protocol administrative
mode for the Switch. The factory default is Disable.
Apply
Click Apply to save the values and update the screen.
The ensuing table for GVRP Information settings are informational only: GVRP.
5.7.6
802.3az EEE
The 802.3az Energy Efficient Ethernet (EEE) innovative green feature reduces energy consumption through
intelligent functionality:
Traffic detection Energy Efficient Ethernet (EEE) compliance
Inactive link detection
Inactive link detection function automatically reduces power usage when inactive links or devices
are detected.
To access this page, click L2 Switching > 802.3az EEE.
Figure 5.27 L2 Switching > 802.3az EEE
The following table describes the items in the previous figure.
Item
Description
Port Select
Enter the port to setup the EEE function.
State
Click Enabled or Disabled to set the state mode of the port select setting.
Apply
Click Apply to save the values and update the screen.
The ensuing table for EEE Enable Status settings are informational only: Port and EEE State.
5.7.7
Multicast
Multicast forwarding allows a single packet to be forwarded to multiple destinations. The service is based
on L2 switch receiving a single packet addressed to a specific Multicast address. Multicast forwarding
creates copies of the packet, and transmits the packets to the relevant ports.
Figure 5.26 L2 Switching > GARP > GVRP Settings
