5 Managing Switch
Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018
47
5.7
L2 Switching
5.7.1
Port Configuration
Port Configuration describes how to use the user interface to configure LAN ports on the Switch.
To access this page, click L2 Switching > Port Configuration.
The following table describes the items in the previous figure.
Item
Description
Port
Click the drop-down menu to select the port for the L2 Switch setting
Enabled
Click the radio-button to enable or disable the Port Setting function.
Speed
Click the drop-down menu to select the port speed: Auto, Auto-10M, Auto-100M,
Auto-10/100M, 10M or 100M.
Duplex
Click the drop-down menu to select the duplex setting: Half or Full.
Flow Control
Click the radio button to enable or disable the flow control function.
Apply
Click Apply to save the values and update the screen.
The ensuing table for Port Status settings are informational only: Port, Edit (click to enter description),
Enable State, Link Status, Speed, Duplex, FlowCtrl Config and FlowCtrl Status.
5.7.2
Port Mirror
Port mirroring function allows the sending of a copy of network packets seen on one switch port to a
network monitoring connection on another switch port. Port mirroring can be used to analyze and debug
data or diagnose errors on a network or to mirror either inbound or outbound traffic (or both).
There are no preset values in the Port Mirror. The displayed values do not represent the actual setting
values.
Figure 5.15 L2 Switching > Port Configuration
