Wieland podis?MOT FA C 1I3O, Operating Instructions Manual, Page: 28 / 60

4.
Wieland Electric | BA000341 | 02.2007
podis
®
MOT FA I C -/I4O Device Description | 4
4. Mechanical design / housing
Based on its mechanical design, the housing of the podis MOT FA I C -/1I4O is divided into an
upper and a lower part.
The upper part contains the electronics for controlling the drive.
The upper part is fastened onto the lower part using four screws.
The base contains the connection technology for the podis energy bus.
The electrical connection between hood and base is implemented via a cable harness from
the base connected to a PCB pluggable connector in the hood.
4.3 Connections, control and display elements
2
1
Connections at the podis
®
MOT
1 ADDR Connection of the AS-i hand-held terminal
2 X1 Interface to the drive
The podis MOT can be addressed using a hand-held terminal. For this purpose, the AS-i hand-
held programming device (part no. 83.209.2205.0) is connected to the addressing jack of the
podis MOT. Additional information about addressing can be found in section 7.1. "Setting the
AS-i slave address at the podisMOT".
Connections at
the podis
®
MOT
FA I C -/I4O
Hood with integrated
electronics
Pluggable connection
between hood and base
Base with connection technology
(hidden by cover plate)
podis ® MOT
FA I C -/I4O
(geöffnet)