Whitmore EasiPoint, Installation & Maintenance Manual

Page: 12 / 27

12
6.10.1 Fit the rail clamps to the Check Rail generally following procedures outlined in the previous
sections. The Blade fixing studs on the clamps should be oriented towards the 4’, clamp
spacing to suit the check rail blades and the full assembly located midway between the
sleepers.
6.10.2 Locate the Check Rail assembly on the two rail clamp studs and tighten the two M16
fasteners securely.
6.10.3 The blade has vertical and horizontal adjustment through setting of the M16 fastenings on
the support bracket. Arrange the blade so that the exit ports are between 1 and 2mm from
the Check Rail face and the blade is horizontal, lock securely in that position.
6.11 Fitting the Delivery Hoses
6.11.1 Fit one end of a delivery hose to the hose tail inlet on the Blade with a hose clip and
measure the other end of the hose to the grease outlet tail of the pump body, cut the hose
and secure it with a hose clip. Ensure that the hose runs under the rails.
6.11.2 Repeat the procedure for the other hose.
6.12 Fill the Hoses and Blades
6.12.1 Using the 10mm “T” bar keep depressing one of the plungers until grease appears onto the
top of the Blade. Do not fully depress plunger, maintain a minimum 1mm clearance with
the pump body.
6.12.2 Repeat for the other Blade.