White Knight B96M8W, Service Manual

Page: 9 / 21

6. Remove the screws holding the PCB to the
control panel. The PCB’s can be removed by
unscrewing and unclipping where necessary.
2. Disassembling the RFI filter and water level sensor
Disassembling the RFI filter:
Remove the loom terminals from the filter. Unfasten
the two screws from the filter in order to remove the
filter from the upper bracket.
Disassembling the water level sensor:
Remove the top cover (screws at rear of appliance)
and left-hand side panel (screws along top, at rear
and underneath appliance) from the appliance.
(1) Pull out the drainage hose connector from the
pump cover.
(2) Remove the pump cover(s)
(3) Remove the nut on water level sensor to
allow the water level sensor to be removed
from the pump cover. Unclip the wires.
3. Disassembling the door
1) Remove the screws holding the hinge to the front
panel. Lift the door to extract the hinge from the
panel and place on a soft surface to avoid scratching
the door.
2) Remove the screws on the inside of the door.
3) The door should now be able to be stripped into
its constituent parts.