WhitakerAudio J C Whitaker 20 W Stereo Audio Amplifier, Manual

Page: 104 / 194

104
WhitakerAudio
the bottom chassis plate. After each terminal is attached to a lead, gently pull on the wire and
terminal to make sure a good crimp has been made.
– Connect PL1 – output transformer plate 1 connection. Find the blue wire from the left
channel output transformer (T2). Install a connector to the end of the wire. Attach to the
PL1 post on the left channel PWB.
– Connect SC1 – output transformer screen 1 connection. Find the blue/yellow wire from
the left channel output transformer. Install a connector to the end of the wire. Attach to the
SC1 post on the left channel PWB.
– Connect PL2 – output transformer plate 2 connection. Find the brown wire from the left
channel output transformer. Install a connector to the end of the wire. Attach to the PL2
post on the left channel PWB.
– Connect SC2 – output transformer screen 2 connection. Find the brown/yellow wire from
the left channel output transformer. Install a connector to the end of the wire. Attach to the
SC2 post on the left channel PWB.
– Connect T2ct – output transformer center tap. Find the red wire from the left channel
output transformer. Install a connector to the end of the wire. Attach to the T2ct post on
the left channel PWB.
Double-check the connections from the left channel output transformer to the PWB.
5.6.7.4 Power Transformer Leads
In the following steps, trim the transformer lead lengths so the wires will comfortably reach their
respective terminals. After each terminal is attached to a lead, gently pull on the wire and terminal
to make sure a good crimp has been made.
– Connect 400V – plate winding. Find one of the two red leads from the power transformer
(T51). Install a connector to the wire. Attach to one of the 400V posts on the rectifier
PWB.
– Connect 400V – plate winding. Find the other red lead from the power transformer. Install
a connector to the wire. Attach to the available 400V post on the rectifier PWB.