Whirlpool WSE 2930 W, Manual

Page: 84 / 101

Troubleshooting
Filter reset after Built-In test sequence
Water Filter Indicator Factory / Service reset:
Press 4 times consecutively (within 10 sec) the water valve shaft switch.
The symbol “F” on the Refrigerator display will be shown in order to confirm the operation.
If a alarm code alarm is being showing, the symbol “F” will cycle together with them.
Antibacterial Filter Indicator Factory/Service reset:
Press 4 times consecutively (within 10 sec) the refrigerator compartment door switch.
The symbol “A” on the Freezer display shall be shown in order to confirm the operation.
If a alarm code is being showing, the symbol “F” will cycle together with them.
At the end of the Built-In Test is and all was OK, it will be displayed the code 00 till the
Built-In Test is completed.
At this time it will be possible to reset to „0“ the Water Filter Indication and / or the
Antibacterial Filter Indication in the following way: