24
COMPLETE INSTALLATION
Check that the power supply wire or cord does not touch
dishwasher motor or the lower part of the dishwasher tub.
Plug into a grounded 3 prong outlet.
NOTE:
With the access panel off, start the dishwasher and
allow it to complete the shortest wash cycle. After the first
2 minutes, unlatch door, wait 5 seconds, then open door.
Check that there is water in the bottom of the dishwasher
tub. Check that dishwasher is working properly.
60.
Power supply cord – Plug into a
grounded 3 prong outlet
61.
Reconnect power
Reconnect electrical power at the fuse box or circuit
breaker box.
1.
Connect rubber end of drain hose
to air gap and cut if needed.
NOTE:
Do not cut ribbed section.
2.
Attach drain hose to air gap with large
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use
a 1
1
/
2
" to 2" (38 to 50 mm) screw-type
clamp (not provided).
3.
Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.
Option D: No waste disposer –
with air gap
Large drain
hose clamp
Drain hose
Screw-type clamps
Air gap
Rubber hose
connector
Drain trap
Waste tee
1
Rubber
end
2
3
29-Aug-2018 12:50:53 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
