FOR SERVICE TECHNICIAN ONLY - DO NOT REMOVE OR DESTROY
PAGE 12
4.
With an ohmmeter, check the continuity from
L1 and N plug terminals of the power cord to the
terminals for L1 and N on the machine control
electronics. See figure 3b.
If continuity exists for both connections,
go to step 6.
If an open circuit is found, check the integrity
of the connections of the power cord to the
harness in the dryer; harness to the machine
control board; and, the integrity of the power
cord itself.
5.
If it is necessary to replace the power cord,
remove the retaining clip that secures the cord
to the back panel. Disconnect the cord from the
main harness, and the ground wire from the rear
panel, then pull out the power cord.
6.
Visually check that the P2 connector is
inserted all the way into the machine control
electronics.
7.
Visually check that the console electronics
and housing assembly is properly inserted into
the front console.
8.
If both visual checks pass, replace the console
electronics and housing assembly.
9.
Plug in dryer or reconnect power.
10.
Perform steps under DIAGNOSTIC: Console
Buttons and Indicators, page 2, to verify repair.
11.
If indicators still do not light, the machine
control electronics has failed:
Unplug dryer or disconnect power.
Replace the machine control electronics.
Plug in dryer or reconnect power.
Perform steps under DIAGNOSTIC: Console
Buttons and Indicators, page 2, to verify repair.
GAS DRYER (U.S. and Canadian Installations):
1.
Unplug dryer or disconnect power.
2.
Remove the cover plate from the top right
corner of the back of the dryer. See figure 2,
page 11.
3.
Check that the power cord is firmly connected
to the dryer’s wire harness. See figure 4.
4.
Access the machine control electronics
without disconnecting any wiring to the control
board. See figure 15, page 21.
5.
With an ohmmeter, check for continuity
between the neutral (N) terminal of the plug and
P8-3 (white wire) on the machine control board.
The left-hand side of figure 5 shows the position
of the neutral terminal (N) on the power cord plug.
Also see figure 16, page 22.
If there is continuity, go to step 6.
If there is no continuity, disconnect the white
wire of the harness from the power cord at the
location illustrated in figure 4. Test the continuity
of the power cord neutral wire as illustrated in
figure 5. If an open circuit is found, replace the
power cord. Otherwise, go to step 6.
P9
1
5
1
P/N
XXXXXX
Rev
X
Date
Code
YDDD
-xx
XXXX
-XXX
MADE
IN
COO
L1
COM
P8
L1
N
Neu
N
Neu
Power Cord
Plug
Machine Control
Electronics
Figure 3b.
Plug-to-terminal connections
for electric dryer.
Wire
Harness
Power
Cord
Figure 4.
Power cord-to-wire harness
connection for gas dryer.
COM
Neu
G
L1
L1
Masse
N
Neu
N
G
Masse
Figure 5.
Power cord terminals, gas dryer.
Power Cord Plug
