Whirlpool FSCR 10431, Health & Safety, Use & Care And Installation Manual

Page: 44 / 54

44
Failure indicator
lights up
Display
message
Possible Cause Possible Solution
FdL
(or F29)
The door cannot unlock . Firmly press the door on the area of the
door lock, then press On/Off for at least 3
seconds .
If hot cycle is selected, wait until cool
down and press again On/Off for at least 3
seconds .
Switch on the washing machine . If failure
still appears, check and eventually remove
possible cause as indicated for failure
“Clean filter” . Then switch the washing
machine on again . If door does not unlock,
press On/Off for at least 3 seconds .
If door still does not unlock, refer to
section “DOOR – HOW TO OPEN IT IN CASE
OF A FAILURE” . Before draining water /
opening the door, wait until the water has
cooled down (for hot wash programmes) .
Call Service
F24
Too much laundry for a
programme with small
maximum load
Too much inlet water
Select and start programme “Rinse and
Spin” to complete the interrupted wash
programme .
Do not overload the washing machine .
Respect the maximum load size of the
programmes indicated in the Programme
Chart .
Turn off the water tap . Press On/Off for at
least 3 seconds to drain the water; wait
until the drain phase has ended (End will
appear on display) .
Turn on the water tap again . – If water
immediately flows into the washing
machine (without having started a
programme), there is a failure of an
electrical component . Close water tap,
switch off and unplug the washing
machine . Contact our After-Sales Service .
Call Service
F02
Water stop failure – water
leakage detected in
bottom tray .
Press Start/Pause . If problem persists, press
On/Off for at least 3 seconds . If failure
persists, contact After-Sales Service .
Call Service
F04 to F99
Failure of an electrical
component
Press On/Off button for at least 3 seconds
to reset the failure . If problem persists,
switch off washing machine, close the
water tap and unplug it; call After-Sales
Service .