PERFORMANCE DATA SHEET
System Model EveryDrop
™
Replacement Filter S3RFWG60NP
This system has been tested according to NSF/ANSI 42 for reduction of substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a concentration
less than or equal to the permissible limit for water leaving the system as specified in NSF/ANSI 42.
The following claims have not been tested and certified by NSF.
Testing conducted at Pace Analytical Services per NSF/ANSI Standard 42.
These contaminants are not
necessarily in your water supply.
While testing was performed under
standard laboratory conditions,
actual performance may vary.
Tested and Certified by NSF International against
NSF/ANSI
Standard 42
for the reduction of chlorine taste and odor.
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to the State of California to cause cancer.
WARNING: This product contains one or more chemicals known to the State of California to cause birth
defects or other reproductive harm.
Substance
Influent challenge concentration
Reduction requirement
Chlorine taste and odor
2.0 mg/L
+/- 10%
>/= 50%
Substance
Influent challenge concentration
Chloramine
2.0 mg/L
+/- 10%
ACTIVATE FILTER
Remove the Replacement Filter from the bag
and fully submerge underwater for 10 minutes.
Then remove the Replacement Filter from the water,
and shake it vigorously for 10 seconds to activate.
1
10
minutes
10
seconds
+
EVERYDROP
™
WATER FILTER COMPONENTS
Cap
Funnel
Filter
Protective
Travel Case
FOR OPTIMAL USE AND CARE
Change your Filter every two months for best performance.
The Cap, Funnel and Travel Case are all top-rack dishwasher safe. Wash
on a regular basis.
Please do not put the Filter in the dishwasher. This may affect the taste of
water coming from your Filter.
Storing the EveryDrop
™
Water Filter in the Protective Travel Case for an
extended period of time could affect the taste of your water.
Do not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after using the EveryDrop
™
Water Filter.
The contaminants or other substances removed or reduced by this Water Filter
are not necessarily in all users’ water.
Ensure the clear o-ring on the Filter is not twisted in any manner. This will
prevent unfiltered water leaks into the filtered water container.
Filter water prior to heating. Maximum water temperature usage is 100°F.
PREPARATION
2
Remove the EveryDrop
™
Water Filter
from the Protective Travel Case.
Twist counterclockwise to separate
the Cap from the Funnel and gently
wash all components with soap and
water. Rinse thoroughly.
Replace the Filter two
months from this date.
FEB
3
After the Filter is activated, place
into the Funnel with the most
current month facing through the
drop window.
FEB
Twist the Cap clockwise onto the
Funnel. The image of the drop in the
window will disappear when it locks
into place. Now, it’s ready to use.
4
On The Go
Use the Protective Travel Case to take
the EveryDrop
™
Water Filter with you,
everywhere you go.
At Home
Place the EveryDrop
™
Water Filter
over any container you wish to fill
with freshly filtered water.
Storage
When not in use, you may store the
EveryDrop
™
Water Filter in either the
bottom of the Protective Travel Case
OR on top of a drinking container.
USAGE & CARE INSTRUCTIONS
Sign Up For The Filter Replacement Program At
www.
everydropwater
.com
* Micro Contaminant Replacement Filter
is not dishwasher safe
*
BPA
FREE
+
DISHWASHER
SAFE
Consumer Support
(800) 442-9991
Water At The Speed Of Life.
™
®
/™ ©2013 Whirlpool. All rights reserved.
Manufactured for Whirlpool Corporation (Benton Harbor, MI) by Koller-Craft South (Gadsden, AL). Made in USA.
