Whirlpool ED5KVEXVQ User Instructions Download

Page: 9 / 53

5. There is no need for routine condenser cleaning in normal

home operating environments. If the environment is
particularly greasy or dusty, or there is significant pet traffic in
the home, the condenser should be cleaned every 2 to
3 months to ensure maximum efficiency.

If you need to clean the condenser:

■

Remove the base grille.

■

Use a vacuum cleaner with a soft brush to clean the grille,
the open areas behind the grille and the front surface area
of the condenser.

■

Replace the base grille when finished.

6. Plug in refrigerator or reconnect power.

Changing the Light Bulbs

NOTE: Not all bulbs will fit your refrigerator. Be sure to replace
the bulb with one of the same size, shape and wattage. On some
models, the dispenser light requires a heavy duty 10-watt bulb.
All other lights require a 40-watt bulb. Replacement bulbs are
available from your dealer.

1. Unplug refrigerator or disconnect power.

2. Remove light shield when applicable.

NOTE: To clean the light shield, wash it with warm water and
liquid detergent. Rinse and dry the shield well.

3. Remove light bulb and replace with one of the same size,

shape and wattage.

4. Replace light shield when applicable.

5. Plug in refrigerator or reconnect power.

TROUBLESHOOTING

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

to possibly avoid the cost of a service call.

In the U.S.A., www.whirlpool.com In Canada, www.whirlpool.ca

Refrigerator Operation

The refrigerator will not operate

■

Power cord unplugged? Plug into a grounded 3 prong
outlet.

■

Is outlet working? Plug in a lamp to see if the outlet is
working.

■

Household fuse blown or circuit breaker tripped? Replace
the fuse or reset the circuit breaker. If the problem continues,
call an electrician.

■

Are controls on? Make sure the refrigerator controls are on.
See “Using the Controls.”

■

New installation? Allow 24 hours following installation for
the refrigerator to cool completely.

NOTE: Adjusting the temperature controls to coldest setting
will not cool either compartment more quickly.

The motor seems to run too much

Your new refrigerator may run longer than your old one due to its
high-efficiency compressor and fans. The refrigerator may run
even longer if the room is warm, a large food load is added, doors
are opened often, or if the doors have been left open.

The refrigerator is noisy

Refrigerator noise has been reduced over the years. Due to this
reduction, you may hear intermittent noises from your new
refrigerator that you did not notice from your old model. Below
are listed some normal sounds with an explanation.

■

Buzzing - heard when the water valve opens to fill the ice
maker

■

Pulsating - fans/compressor adjusting to optimize
performance

■

Rattling - flow of refrigerant, water line, or from items placed
on top of the refrigerator

■

Sizzling/Gurgling - water dripping on the heater during
defrost cycle

■

Popping - contraction/expansion of inside walls, especially
during initial cool-down

■

Water running - may be heard when water melts during the
defrost cycle and runs into the drain pan