Whirlpool DP840DWG, Manual

Page: 16 / 66

12
Dishwasher Dispenser Assembly
1. Assembly the upper slide, slide spring
and lower slide to the detergent
door actuator.
(Fig. 1-32)
2. Pass the detergent door latch lever
through the panel making sure to turn the
hook of the latch toward the detergent
door. Snap the detergent door latch snap
onto the door latch lever.
(Fig. 1-31)
3. The door latch lever must pass through
the opening in the lower slide. Press the
actuator assembly into position until the
upper and lower tabs engage.
4. Insert the diaphragm and diaphragm
spring into the wet agent dispenser. Seat
the diaphragm flush with the surface of
the dispenser.
(Fig. 1-30)
5. Install the upper and lower slides into the
wet agent dispenser actuator.
6. Press the wet agent dispenser actuator
into position on the dispenser so the lock-
ing tabs engage.
7. Press the wet agent dispenser assembly
into position so the locking tabs engage
the wet agent cap opening. No tool is
needed for assembly.
(Fig. 1-29)
8. Install the seal on the wet agent cap.
9. Insert the wet agent cap. Turn it clock-
wise and close it.
10. Slide the upper and lower drawbars
together.
(Fig. 1-28)
11. Move all slides in both assemblies fully
down. Keep the drawbars slid fully to-
gether and align the drawbar holes over
the locking tabs. Look behind the draw
bars and make sure to engage the locat-
ing tabs with their respective locating
holes. Press the drawbars into position
and slide them upward behind the locking
tab ears.
(Fig. 1-27)
12. Install the drawbar spring.
(Fig. 1-26)
13. Install the drip cover by snapping it into
place.
Fig. 1-32