background image

Quick Reference Guide 

GB

Crockery holders:

• Down: cups and long-stemmed 

glasses.

• Up: plates.

Half load button / Multizone:

If only the upper rack is to be loaded, 
remove the cutlery basket from the lower 
rach and place it in the upper one.

Height adjustment:

(The dishwasher is delivered with the 
upper rack in the top position).

The rack height can also be changed 
when loaded.

• To lower: pull out the two side 

handles and gently lower the rack. 

• To raise: pull up the two side 

handles until the rack clicks into 
place.

• The rack must be level on both 

sides.

Lower rack

Half load button / Multizone:

Loading the lower rack only: greater 
washing power, particularly for plates 
and saucepans.

Cutlery basket:

The cutlery basket can be removed to 
increase available space.

Plate holders:

• May be removed to increase 

available space.

• To remove: pull the handle up.
• To reposition: simply insert in the 

required position (normal or 
crosswise). 

Daily check list

1. Arrange crockery so that items do 

not touch each other.

2. Load cups at an inclination to 

facilitate water circulation.

3. In general, place the cutlery in the 

basket with the handles positioned 
downwards, but ensure that sharp 
knives and forks that might cause 
injury are placed in the basket with 
the handles positioned upwards.

4. Make sure the water jet can reach 

all loaded items and that the spray 
arms rotate freely.

5. Turn on the water supply tap before 

starting the dishwasher.

Important:

Switch off the dishwasher once 
the “Start” indicator lamp has 
switched off. If you switch off the 
dishwasher during a wash cycle, 
when switched on again the 
dishwasher resumes the cycle 
from where it was interrupted.

If a fault occurs or you wish to 
change the current programme, 
press the “START” button for 
about 5 seconds until the Start 
indicator lamp switches off ! 
Refer to the “Troubleshooting 
Guide” in these user instructions 
to remedy any problems.

• If regeneration salt is to be 

added, IMMEDIATELY start 
a washing programme, to 
eliminate any residual salt.

Sometimes even when the 
regeneration salt container is full, 
the corresponding indicator 
lamp may illuminate during the 
first wash cycle.

Upper rack

Reviews: