GB -1-
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
1)
Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on conditions.
Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2)
Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.
3)
The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres
kWh
Minutes
1)
P1
6th Sense
Power
Clean
40°-70°C
Delay
Power Clean
Use for normal soiled dishes with dried-on food.
Senses the level of soiling on the dishes and
adjusts the program accordingly. When the sensor
is detecting the soil level an animation appears in
the display and the cycle duration is updated. The
Power Clean option is activated automatically
with this program. To deactivate, press the Power
Clean button on the control panel.
X
7-14 1.00-1.65
80-165
Full
P2
Pre-Wash
cold
Delay
Crockery to be washed later.
—
4.0
0.03
14
NO
P3
Fragile
40°C
Delay
Light soiling, for example glasses and cups.
X
10.0
0.85
100
Light
P4
Rapid
45°C
Delay
Lightly soiled crockery, with no dried-on food.
X
11.0
0.80
30
NO
P5
Eco
2)
50°C
Delay
Power Clean
Normally soiled crockery.
Energy-saving program.
X
11.0
0.92
230
Full
P6
Fast Daily
60°C
Delay
Normally soiled crockery.
X
10.0
1.30
80
Full
P7
Intensive
65°C
Delay
Power Clean
Recommended program for heavily soiled crockery,
especially suitable for pans and soucepans.
X
14.0
1.60
145
Full
P8
Hygiene
3)
Delay
Power Clean
Normally or heavily soiled crockery, with additional
antibacterial wash. Program interruption (e.g. due to
door opening) can compromise elimination of
germs.
X
13.0
1.50
118
Full
5019 396 03695
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
POWER CLEAN
Thanks to the additional
power jets this option
provides a more intensive
and powerful wash in the
lower rack, in the specific
area. This option is
recommended for washing
pots and casseroles (see page
4). Press this button to
activate Power Clean (the
indicator lights up).
For non Power Clean loading
to achieve best cleaning
performances and resources
optimization, Power Clean
should be switched off.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
DELAYED START BUTTON
Push the button (repeatedly)
to delay the start of the
program. Adjustable from 1 to
24 hours. With each press of
the button, the delayed start
indicator increases by one
hour and after 24 restarts from
0. Then press the START
button. The dishwasher will
start after the set time.
TABLET SETTING
This setting allows to optimize
the cycle performances
according the type of detergent
used. Push the Tablet button
for 3 seconds (until the
indicator lights up) if you are
using the combined detergents
in tablet (rinse aid, salt and
detergent in 1 dose). If you are
using powder detergent or
liquid detergent, the Tablet
indicator on the control panel
has to be off.
Quick reference guide
Whirlpool is a registered trade mark of Whirlpool USA
