WH/II/FD/GB
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Press the ON button.
(The first time you use the appliance
and when using a different type of
detergent)
1. Select the third programme from the
top in the relative table.
2. Press the Start button for about 7
seconds until the display changes.
3. Select the required detergent with the
Start button: “3h” = 2in1, “6h” = 3in1, “9h” = All in 1, all three LEDs
on = soap powder (factory setting).
4. Switch the appliance off and then switch it on again. The type of detergent
selected is shown by the relative LED for approximately three seconds.
For dosage of powder detergent in compartment A and B refer to the
programmes table.
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator D. Electric
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press P or
until the selected programme lights up.
If necessary the corresponding indicator lights up.
The selected programme is
then memorised (even in the
event of power failure).
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the OFF button.
All the indicator lamps switch off.
Warning: When the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Open the door,
switch on the appliance
Select, save, and
supply the detergent
A
B C
Check the rinse aid level
Check the
regeneration salt level
Load the racks
Select a programme
Select additional options
Press the Start button
“Change programme in progress”
Press the START button for 2 sec. until the
Start indicator lamp switches off.
Select another programme and press the
START button again.
Turn on the water tap,
close the dishwasher door
W
a
sh cycle
Switch off the appliance
Turn off the water tap,
unload the racks
