10
Custom cabinet installation:
Drain System
The drain system can be installed using a floor drain, wall
standpipe, floor standpipe, or laundry tub. Select the method you
need.
IMPORTANT:
To avoid siphoning, no more than 4.5" (114 mm) of
drain hose should be inside standpipe or below the top of wash
tub. Secure drain hose with cable tie.
Floor standpipe drain system
Minimum diameter for a standpipe drain: 2" (51 mm). Minimum
carry-away capacity: 17 gallon (64 L) per minute. A 1/4" (6 mm)
diameter to 1" (25 mm) diameter Standpipe Adapter Kit is
available (Part Number 3363920). Top of standpipe must be at
least 39" (991 mm) from the floor; install no higher than
96" (2.44 m) from bottom of machine. If you have an overhead
sewer and need to pump higher than 96" (2.44 m), a sump pump
and associated hardware are needed. See “Alternate parts.”
Wall standpipe drain system
See requirements in the “Floor standpipe drain system” section.
Laundry tub drain System
Minimum capacity: 20 gallon (76 L). Top of laundry tub must be at
least 39" (991 mm) from the floor; install no higher than
96" (2.44 m) from bottom of machine.
Floor Drain System
Floor drain system requires a Siphon Break Kit, two Connector
Kits, and an Extension Drain Hose that may be purchased
separately. Please contact your retailer for ordering information, or
see the “Assistance or Service” on Quick Start Guide. Minimum
siphon break height: 28" (710 mm) from bottom of machine.
(Additional hoses may be needed.)
