Whirlpool 8177945, Manual, Page: 21 / 40

3-9
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
1. Turn off the gas and electrical power going
to the range.
2. Pull the range away from the wall so that
you can access the rear panel.
3. Remove the five screws from the rear
cover. Pull the bottom of the cover out so
the flange is free of the oven, and slide the
cover down to remove it.
CAUTION: When you work on the gas range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
Screw (1 of 5) Rear Cover
4. Disconnect the three wire connectors from
the electronic oven control’s power supply
board and pull the ribbon cable out of its
connector (do not touch the ribbon cable
contacts). Unhook the tabs from the top
and bottom edges of the power supply
board.
5. Fold the power supply board back out of
the way and unhook the tabs from the top
and bottom of the display board. Note the
board alignment tab for reassembly.
REMOVING THE ELECTRONIC OVEN CONTROL ASSEMBLY
6. To remove the touchpad assembly, re-
move the two screws from the touchpad
frame and remove the assembly from the
control panel.
Touchpad Frame
Screw
Screw
3 Wire Connectors
Tab (1 of 6)
Ribbon Connector
Tabs (3 of 6)
Power Supply Board Display Board
Alignment Tab