BDA CS 300
– 06/15 – REV. B
Page 59 / 84
5
Transport and Installation
5.1
Transport
The weight of the electric Crimping Machine CS 300 is approx. 17 kg.
CAUTION
+
Use sufficiently dimensioned hoisting device for the transport of the crimping machine.
+
To lift the crimping machine use the handle recesses on the machine.
ATTENTION
+
Cables must not be damaged.
+
During transport and installation of the machine wear suitable safety shoes.
5.2
Installation
ATTENTION
+
Position the electric Crimping Machine CS 300 on a flat surface and assure the stability of
the machine. Ensure that the table or bench is stable enough to support the machine in
normal use.
+
Assure an appropriate table height. The table height is depending on the position of the
operator, (work in sitting or standing position) according to prEN 894-4:2004, Table A.1.
+
The crimping machine has no own light source. Assure an appropriate illumination of the
working place. (EN 1837:1999
– chapter 4.2: “The general value of illumination has to be
500 lx [...]").
Place the foot pedal on the floor. No other place is allowed! The foot pedal must be movable,
so that the operator has the possibility to change his position for ergonomic and production
needs.
ATTENTION
+
Place the cables on the floor so that they do not cause a trip hazard.
+
Do not lay the foot pedal in aisles or walk ways.
+
Assure free access to the operating elements of the machine, especially the foot pedal
and the release button (latching).
+
During transport and installation of the machine wear suitable safety shoes.
INFORMATION
+
To work fatigue-proof, the user has to take a working position where the machine is at the
right height and the foot pedal is accessible. The foot pedal has to be installed in a stable
position. The position of the foot pedal should be chosen in that way, that a free access
will be possible.
+
The noise level of the machine is max. 69 dB(A).
