Wexxar WF30T, Operation And Service Manual

Page: 80 / 190

WF30T Case Former Case Size Adjustments
7-67
7.7 Feedbelt Horizontal Adjustments (Dimension
‘H’)
Loosen the red clamp handles and adjust the red feedbelts so that they support the case evenly.
The most typical position for the feedbelts is in the center of each minor panel of the flat case
blank to ensure that the weight of the flat case blank is balanced on the two belts.
Figure 7-21: Red Clamp Handles
Figure 7-22: Feedbelt Positions
When adjusting the feedbelt positions, it is important that they be set parallel to the fixed fence
side guide for proper feeding.
Check the ‘S’ box for Satisfactory Performance and ‘US’ box for Unsatisfactory Performance.
Table 23: Dimension 'H' Adjustments
Size Adjustments
Feedbelt Center Adjustment (Dimension ‘H’)
S US
Loosen the 4 red quick-adjust ‘H’ handles as shown in Figure 7-21.
Adjust the position of the feedbelts, while ensuring that they are parallel.
Retighten quick-adjust handles.
Adjust
parallel to
fixed
fence
Position belts to support case evenly,
usually under the center of each
panel
Red clamp handles