Wexxar WF-10T, Operation And Service Manual

Page: 71 / 156

WF-10T Case Former Case Size Adjustments
7-59
Check the ‘S’ box for Satisfactory Performance and ‘US’ box for Unsatisfactory Performance.
Table 15: Dimension ‘D1’ Adjustments
Size Adjustments
Jawplate Formed Case Width Adjustment (Dimension ‘D1’)
S US
Measure the outside dimension of the formed case width on the scale
provided.
Press any
‘EMERGENCY STOP’
button and open the operator’s side
guard door.
Loosen the four quick-adjust handles (2 in front and 2 in the rear) that
secure the jawplate assembly to the carriage assembly.
Pivot the free-moving jawplates until they are in-line with the linear
carriage guide track.
Turn the Dimension ‘D1’ hand crank until the ‘D1’ pointer reaches the
measured formed case width.
Place an opened case blank on the jawplates such that the pins
engage the outside edges of the bottom major flaps.
Retighten the four quick-adjust handles.
Remove the opened case from the pins and pivot the jawplates so
that they are perpendicular to the direction of carriage travel.
Ensure that jawplates are aligned parallel to each other.