WD-100GR
Rev. 5.0 (202207)
Installation instructions
20
3.7
Trial operation
Prepare the machine for trial operation by following the OPERATION INSTRUC-
TIONS. The instructions describe the measures that must be taken to prepare the
machine for operation.
3.7.1
Start-up schedule
This should be completed and signed by the customer on start-up.
Read the installation and user manuals carefully. Then check the following points:
1. Check:
•
Water and waste pipe connections
•
That the machine is evenly balanced
•
That the cassette can easily be moved in and out of the machine
•
The equipment for detergent and drying agent is correctly connected
•
The filter, filter tray, cover plates and level pipe should be in position
•
The right amount of granules should be in the machine
•
That the overheating protection device is reset
•
That the FU21 and FU42 mini-switches are in the off position
•
That QM17 is switched on
2. Filling the dishwasher with water:
•
Open the tap(s) to the dishwasher’s water connection and fill the break tank
with water (possible option)
•
Vent the booster pump (possible option)
•
Start the dishwasher
•
Check the direction of rotation of the pumps
N.B.! If the pump is rotating in the wrong direction, the phase must be in-
verted on the incoming electrical cable connection
•
Fill the machine with water in accordance with the OPERATION INSTRUC-
TIONS
•
Turn on the mini-switches FU21 and FU42 when the booster heater and
tank have filled with water
3. Check the setting of the reference values:
•
All the reference values have been set to the recommended values on de-
livery
•
Check the temperatures
Machine type:
Machine serial number:
Installation date:
Summary of Contents for WD-100GR
Page 2: ......
