Westward High Lift
Vehicle Stands
Operating Instructions Manual
4GU80A
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself
and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions
for future reference.
®
Description
Westward High Lift Vehicle Stands are designed to support rated capacity loads over
extended periods. Heavy gauge steel frame helps prevent distortion and twisting. These
high lift vehicle stands are designed to meet applicable ANSI/PALD Standards.
Note: Rated Capacity is Per Pair ONLY! Use ONLY one pair per vehicle.
General Safety Information
Study, understand,
and follow all
instructions before operating this device.
Rated capacity is per pair! Do not exceed
rated capacity. Use only on hard level
surface. Center load on saddle. Use as a
matched pair to support one end of a
vehicle only. Use only one pair per vehicle.
Stands are not to be used to
simultaneously support both ends or one
side of a vehicle. No alterations shall be
made to this product. Failure to heed
these markings may result in personal
injury and/or property damage.
Before Use
1. Before using this product, read the
operator’s manual completely and
familiarize yourself thoroughly with the
product and hazards associated with
its improper use.
2. Use high lift vehicle stands in pairs on
hard level surface capable of
sustaining rated capacity loads. Use
one pair per vehicle.
3. Insert roll pin into the bottom hole of
the extension tube.
4. Load and stands must be stable before
working on, around, or under load.
5. Inspect before use. Do not use if bent,
broken, cracked, or otherwise damaged
components are noted.
6. Consult vehicle manufacturers service
manual for proper lifting and support
locations.
Operation
TO SUppOrT
1. Adjust height by pulling up extension
tube. Ensure stopper is positively
engaged into extension tube. Place
stands under support points.
2. Lower the load slowly onto the stands.
Do not remove lifting device.
IMpOrTANT:
Stopper must be securely
inserted.
TO reMOVe
1. With suitable lifting device, raise
vehicle clear of stands.
2. Release stopper and allow extension
tube to glide down to lowest position.
3. Carefully remove stands, then slowly
lower vehicle with lifting device.
Maintenance and Storage
Periodically inspect product. Ensure all
parts move freely. Do not apply oil or
grease to this product. Wipe clean before
use. Maintain labels and replace as
needed, contact your local Grainger.
Store stands in upright position and in a
clean, dry area. Place stopper in stopper
holder on base section.
NOTe:
Other than Label and Manual, No
replacement parts available for these
units. Replace as a matched pair only.
Specifications
Min.
Max.
Model
Capacity
Base Size
Height
Height
4GU80A
10 Ton
16” x 16”
28-
1
/
4
"
47"
Roll Pin
Stopper
Saddle
Base Section
Height Adjustment
Holes
Figure 1- High Lift Vehicle Stand Components
Collar
SHI 032
Printed in China
02/10
Stopper Holder
Lanyard
Extension tube
