Westward Heavy Duty
Vehicle Stands
Operating Instructions Manual
1AVP8
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.
®
Description
Westward Heavy Duty Vehicle Stands are designed to support rated capacity loads,
typically vehicles, over extended periods. Heavy gauge steel frame helps prevent
distortion and twisting. These vehicle stands are designed to meet applicable
ASME/ANSI - PALD Standards.
Note: Rated Capacity is Per Pair ONLY! Use ONLY one pair per vehicle.
General Safety Information
Study, understand,
and follow all
instructions before operating this
device. Rated capacity is per pair! Do
not exceed rated capacity. Use only on
hard level surface. Center load on
saddle. Use as a matched pair to
support one end of a vehicle only. Use
one pair per vehicle. Stands are not to
be used to simultaneously support
both ends or one side of a vehicle. No
alterations shall be made to this
product. Failure to heed these
markings may result in personal injury
and/or property damage.
Before Use
1. Before using this product, read the
operator’s manual completely and
familiarize yourself thoroughly with
the product and hazards associated
with its improper use.
2. Use vehicle stands in pairs on hard
level surface capable of sustaining
rated capacity loads. Use one pair
per vehicle.
3. Make sure load and stands are stable
before working on and around.
4. Inspect before use. Do not use if
bent, broken, cracked, or otherwise
damaged components are noted.
5. Consult vehicle manufacturers service
manual for proper lifting and
support locations.
Operation
TO SUPPORT
1. Adjust height by pulling up
extension tube, then insert support
pin through the appropriate holes in
the extension tube. Ensure the
support pin is secured and properly
engaged.
2. Place stands under support points.
Ensure that load is on center of
saddle.
3. Lower the load slowly onto the
stands. Do not remove lifting device.
4. Ensure vehicle is secure before
working on, around or under. When
used to support vehicle, use wheel
chocks to prevent inadvertent
movement.
TO REMOVE
1. With suitable lift device, raise vehicle
clear of stands.
2. Release support pin and allow
extension tube to glide down to
lowest position.
3. Carefully remove stands, then slowly
lower vehicle with lift device.
Maintenance and Storage
Periodically inspect product. Ensure all
parts move freely. Do not apply oil or
grease to this product. Wipe clean
before use. Store stands in upright
position and in a clean, dry area. Place
stopper in stopper holder on base
section.
NOTE:
Other than Label and Manual,
No replacement parts available for this
device. Replace as a matched pair only.
Specifications
Min.
Max.
Model
Capacity
Base Size
Height
Height
1AVP8
22 Ton
9
7
/
8
” x 9
7
/
8
”
12
1
/
4
”
19
7
/
8
”
Support Pin
Lanyard
Saddle
Base Section
Height Adjustment Holes
Figure 1- Vehicle Stand Components
Handle
SHI 035
Printed in China
07/06
Collar
Bar Holder
Extension Tube
