FIGURE 4
Pivot
Knob
Mixing Shaft
Pivot Pin
(Inside)
Pivot
Knob
Post
FIGURE 5
Set
Screws
FIGURE 6
Clear
Lid
8. While holding the Mixing Shaft in
place, pull the Pivot Knob out until
it stops. Align the Mixing Shaft with
the Brass Pivot Pin. Slowly release
the Pivot Knob to allow the Brass
Pivot Pin to seat in the Bushing
(FIGURE 4).
9. Tighten the second Set Screw
under the Pivot Knob Post until it
stops (make sure the Set Screw
fits in the notch on the Pivot Knob
shaft). Loosen the Set Screw ½
turn to allow the Pivot Knob to
rotate freely
(FIGURE 5).
10. Install the Handle onto the Drive
Shaft.
11. Install the Clear Lid
(FIGURE
6)
. DO NOT use the Meat Mixer
without the Clear Lid in place.
Severe injury could result!
CAUTION!
KEEP FINGERS AND HANDS AWAY from the Mixing Shaft and Paddles during use. NEVER reach into the MIxing Tub
while the Mixing Shaft and Paddles are in motion.
NEVER reach into the Mixing Tub with an elcetric grinder attached to the Meat Mixer and connected to a power source.
KEEP CHILDREN AWAY. NEVER LEAVE THE MEAT MIXER UNATTENDED. SEVER INJURY MAY RESULT.
ALWAYS disconnect the electric grinder from the Meat Mixer when not in use.
Make sure the Mixer is completely assembled and all parts are locked into position before using.
DO NOT mix bones or other hard objects.
READ & FULLY UNDERSTANF ALL INSTRUCTIONS & WARNINGS PRIOR TO USING THIS UNIT. YOUR SAFETY IS
MOST IMPORTANT.
ENGLISH INSTRUCTIONS
6
