ESF-WH-071
1
2
ESF-WH-071
WARNINGS:
•
Operating temperature: -22°F to 113°F (-30°C to 45°C).
•
Suitable for dry and wet locations.
•
This device can not be intended for use with emergency exits.
•
Turn off the power before installation.
•
Installation requires knowledge of electrical systems. Installation to be performed by a
qualified electrician. Don't attempt installation if not qualified.
Preparation for installation
Step 2: Insert the circuit wires through the
center hole in the mounting base.
Step 3: Drill two holes and install the mounting
base.
Step 1: Remove the pipe cap from the center
hole.
Step 5: Tighten the screws, insert end caps,
and adjust fixture body to the mounting base.
Step 4: Connect the circuit wires to the fixture
wires using wire nuts and electrical tape for a
more secure connection.
Ceiling mount
:
Type 1: Wires through the center hole
WIRE DIAGRAM:
Replacing HPS/HID lamp
Connect directly
AC120
-277V
HPS/HID
LED
Black
White
Black
White
Remove fixture from the mounting base.
Ignitor
LED Vapor Proof Fixture
Installation Instruction
INSTRUCTION MANUAL
COMMERCIAL SERVICE
AC120
-277V
Green