STEP 1.
STEP 2.
STEP 3.
Remove the contents from the box and check for any damage. Verify all parts against the parts list.
Read and understand instructions completely before beginning installation.
For this installation you will be removing and reinstalling the lower body cladding to gain access to the
pinch weld of the vehicle.
To remove the lower body-caldding, remove the three pushpins on the wheel wells of the vehicle (2 are in
the front and 1 is in the rear). There are also five pushpins to remove on the lower part on the body
cladding (save the pushpins), you will reinstall at a later time.
From the front wheel well on the pinch weld measure back to the rear of the vehicle. Make marks with a
marker or grease pen at 12”, 31 1/4”, 46” and 60 1/2”.
After marking the suggested locations, there should be four equal marks on the pinch weld. Drill on the
center of the pinch weld a pilot hole using 1/8” drill bit and then make it bigger to a 5/16” hole.
Use four pinch weld hangers per side. Install the pinch weld hanger using 5/16” hex head bolts, washers
and nylock nuts. Make sure to tighten at this time.
Reinstall the body cladding and all pushpins from Step 3.
Install your brackets on the appropriate locations 1, 2 and 3 on the vehicle on the pinch weld hanger
using a 5/16” hex head bolt, washer and nylock nut. Snug up at this time.
In location 4, under the vehicle there is one access hole on the floorboard of the vehicle. Use this hole
and insert the 1/2” anchor bolt, then hang the rear bracket in place using 1/2” nut and lock washer.
SEE FIGURE 1.
SEE FIGURE 2.
SEE FIGURE 3.
SEE
FIGURE 4.
SEE FIGURE 5.
SEE FIGURE 6.
SEE
STEP4.
STEP 5.
STEP 6.
STEP 7.
STEP 8.
STEP 9.
HARDWARE KIT
16 5/16-18 X .75” SQUARE HEAD BOLT
32 5/16” FLAT WASHER
18 1/4-14 X .75” TEK SCREW
32 5/16” NYLOCK NUT
16 5/16” HEX HEAD BOLT
2 1/2” LOCK WASHER
2 1/2” HEX NUT
2 1/2” ANCHOR BOLT
2 FRONT MAIN BRACKET
4 FRONT CENTER BRACKET
2 REAR MAIN BRACKET
8 PINCH WELD BRACKET
STEP BOARD KIT #27-1405
INSTALLATION INSTRUCTIONS
APPLICATION: 2002-05 SATURN VUE
CAUTION:
BEFORE BEGINNING
THIS INSTALLATION
PROCEDURE.
READ THROUGH
INSTRUCTIONS
CAREFULLY AND
COMPLETELY
75-0357 REVISION A 6/29/07
2
3
4
5
6
