Western Digital ActiveScale P100, Support Manual

Page: 47 / 140

ActiveScale™ P100 Support Guide
45
1. From the rear of rack, with the label facing down, insert the transceiver into the Management port.
2. Push on the rear of the transceiver until there is an audible click.
Figure 3-31. QSFP+ transceiver installed
3. Insert both of the fiber optic cables into the QSFP+ transceiver.
3.2.4 Replacing System Interconnects
Caution: If your System Interconnects use a custom configuration, contact
Western Digital Corporation support to obtain the custom configuration file
before proceeding.
Table 3-15. System Interconnect Replacement Overview
Caution: Taking down a System Interconnect for replacement will limit
bandwidth availability.
3.2.4.1 Removing a System Interconnect
To remove a System Interconnect:
Required tools Personnel required Replacement time
None 1 60 to 75 minutes