Page
34
of
54
Maintenance and servicing
Fig. 18 - Changing the wire brush
braids
11.4
Replacing the brush element
If the braided wires show signs of wear or defects, it is possible to replace each
wire brush braid with a new one individually. Please follow the steps below.
Removal and attachment of wire brush braids
Empty the fuel tank of the WKB 660 Honda to be able to tilt the power sweeper.
Now tilt the power sweeper backwards to enable access (lay handles on the
floor to stabilise the machine and ensure safe access).
Risk of crushing due to falling weed brush!
The weed brush can uncontrollably be tilted by external influences, thus
causing dangers.
Therefore:
Tilt the weed brush by carefully following the steps.
If necessary, secure the weed brush in its position by placing
additional weight on the handle.
Fig. 19 - Replacing the brush element
The wire brush braids are located in one of the three mounting consoles. Each
mounting console has four mounting points for the separate wire brush braids.
The braided wire can easily be pulled out from below by unlocking the mini
indexing plungers as shown in the figure. If the other braided wires show similar
signs of wear, this step must be repeated.
Reassemble by following the disassembly steps in reverse order.
