LG3101W Owner’s Manual
Location of Controls
1. Battery Compartment*
2. Motion Sensor
*On back of unit
Screw Installation:
1. Remove the back cover of unit by turning the cover counterclockwise, use the
cover as a guide to drill two (2) holes in the location where you want to mount
the light.
2. Place screws (included) in the pre-drilled holes and tighten.
3. Fasten the light to the back cover by aligning tabs and turning light clockwise.
Motion Sensor
The light features a Motion Sensor which when activated will turn the light ON
automatically when motion is detected. The light will also shut OFF automatically,
after 30 seconds when no motion is detected. Detects motion up to 10ft from the
motion sensor.
Perfect for outdoor walkways and decks.
Motion sensor is designed to detect motion within 10 feet of sensor. For best
operation wave hand at a medium speed in front of motion sensor to activate
light.
Powering the Light
If the LEDs appear to be dim this is an indication that your batteries need to be
replaced.
Inserting/Replacing the Batteries:
1. Slide off the battery compartment.
2. Insert three new C batteries.
3. Make sure to follow battery polarity guide when installing new batteries.
4. Replace battery compartment housing.
Battery Precautions:
1. Use only the size and type of batteries specifi ed.
2. Always purchase the correct size and grade of battery most suitable for the
intended use.
3. Be sure to follow the correct polarity when installing the batteries as indicated in
the battery compartment.
Reversed batteries may cause damage to the device.
4. Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium)
batteries.
5. Replace all batteries of a set at the same time. Do not mix old and new
batteries.
6. Clean the battery contacts and also those of the device prior to battery
installation.
7. Do not dispose of batteries in fi re.
8. Remove batteries if consumed or if product is to be left unused for an extended
period of time.
FCC Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Modifi cations to this product not approved by the party responsible for
compliance could void the user’s authority to operate the product.
MOTION ACTIVATED LED CEILING LIGHT
1
2
Limited Warranty
Under normal use and conditions, AmerTac provides to the original purchaser of this product
a one year limited express warranty that is set forth in the Limited Warranty stated in full at
www.amertac.com/warranties. The Limited Warranty is in lieu of all other express or implied
warranties or liabilities subject to the exceptions explained fully in the Limited Warranty on
the website.
250 Boulder Dr.
Breinigsville, PA 18031
610-336-1330
www.amertac.com
Made in China / Fabriqué en
Chine / Fabricado en China
© 2018 AmerTac™
I18-0038-A